碳酸钙目数对造纸法再造烟叶物理与烟气指标的影响
Effects of Calcium carbonate mesh on physical and smoke indexes of paper-process reconstituted tobacco
-
摘要: 在造纸法再造烟叶中加入不同目数的碳酸钙,做出片基与成品,测定其物理指标与常规烟气指标,分析片基与成品物理与常规烟气指标随碳酸钙目数增加的变化情况.结果表明,从物理指标看,随着填料目数的增加,片基与成品的抗张强度、耐破强度、填充值和平衡含水率整体上都呈增加的趋势,而松厚度呈下降趋势,但总体上碳酸钙目数对成品物理指标的影响没有对片基的影响显著;从常规烟气指标看,碳酸钙目数较高时,再造烟叶片基和成品CO含量、焦油含量、总粒相物含量较大,碳酸钙目数对成品常规烟气指标中水分、CO量/焦油量比、抽吸口数、烟气烟碱影响较小.如果考虑降低再造烟叶CO释放量,碳酸钙的目数不宜过高,以保持在600目以下为宜.Abstract: Four kinds of film base and product were producted by adding different mesh of Calcium carbonate in paper-process reconstituted tobacco, whose physical and smoke indexes were tested. As the change of physical and smoke indexes of film base and product with the increase of Calcium carbonate mesh was analyzed.The results showed that physical indexes including tensile strength, burst strength, filling value and equilibrium moisture content of film base and product all presented an increasing trend except the bulk index declined. Overall, the effect of Calcium carbonate mesh on physical indexes of paper-process reconstituted tobacco was more remarkable than the film base. The smoke indexes testing results showed a higher Calcium carbonate mesh would lead to higher carbon monoxide, tar and total particulate matter in paper-process reconstituted tobacco and film base smoke, the effect of Calcium carbonate mesh on moisture, CO/tar ratio, the number of puffs and nicotine content in product smoke was smaller. In order to decrease the carbon monoxide content in product smoke, the mesh of Calcium carbonate should be smaller. The appropriate mesh was under 600 mesh.
-
-
[1]
郭盛.造纸法薄片生产工艺的研究[D].湖北:湖北工业大学,2008.
-
[2]
孙霞,孙文强.造纸法烟草薄片的研究现状及应用展望[J].华东纸业,2010,41(4):34.
-
[3]
闫克玉.卷烟烟气化学[M].郑州:郑州大学出版社,2002.
-
[4]
Baker R R,Coburn S,Liu C.The pyrolytic formation of formaldehyde from sugars and tobacco[J].J Anal Appl Pyrol,2006,77:12.
-
[5]
Baker R R,Coburn S,Liu C,et al.Pyrolysis of saccharide tobacco ingredients:a TGA-FTIR inveagation[J].J Anal Appl Pyrol,2005,74:171.
-
[6]
Baker R R,Coburn S,Liu C.The pyrolytic of tobacco ingredients[J].J Anal Appl Pyrol,2006,77:12.
-
[7]
张优茂,李旭华,黄翼飞,等.卷烟燃烧峰值温度对主流烟气CO释放量的影响[J].中国造纸,2011,30(9):39.
-
[8]
宋振兴,李元实,乔跃辉,等.降低卷烟主流烟气中CO的研究进展[J].郑州轻工业学院学报:自然科学版,2011,26(6):41.
-
[9]
邱晔,王建,卢伟.国内外造纸法烟草薄片的烟气主要有害物释放量研究及其烟气危害性评估[J].现代科学仪器,2010(3):85.
-
[10]
邱晔,卢伟,王建,等.造纸法烟草薄片对卷烟CO释放量影响研究[J].云南大学学报,2010,32(S1):130.
-
[11]
-
[12]
殷艳飞,王浩雅,向海英,等.造纸法再造烟叶对卷烟CO释放量影响的研究进展[J].中国造纸学报,2013(2):56.
-
[13]
李成刚,王爱霞,王红霞.碳酸钙加入量对造纸法再造烟叶物理质量的影响[J].生物技术世界, 2012(5):39.
-
[14]
贺磊,吴立群,刘攀,等.造纸法再造烟叶表面涂布碳酸钙工艺[J].烟草科技,2013(12):5.
-
[15]
曾健,陈克复,谢剑平,等.碳酸钙对造纸法再造烟叶片基的影响[J].烟草科技,2013(10):5.
-
[1]
计量
- PDF下载量: 30
- 文章访问数: 1027
- 引证文献数: 0