结构参数对微通道换热器内流体分配均匀性的敏感性分析

袁培; 孙冰; 吕彦力; 李丹

doi:10.3969/j.issn.2096-1553.2016.3.010

May 2016

Article Contents

YUAN Pei, SUN Bing, LYU Yan-li and et al. The sensitivity analysis of fluid distribution uniformity on the structure parameters for micro-channel heat exchanger[J]. Journal of Light Industry, 2016, 31(3): 74-80. doi: 10.3969/j.issn.2096-1553.2016.3.010

Citation: YUAN Pei, SUN Bing, LYU Yan-li and et al. The sensitivity analysis of fluid distribution uniformity on the structure parameters for micro-channel heat exchanger[J]. Journal of Light Industry, 2016, 31(3): 74-80. doi: 10.3969/j.issn.2096-1553.2016.3.010 shu

The sensitivity analysis of fluid distribution uniformity on the structure parameters for micro-channel heat exchanger

College of Energy and Power Engineering, Zhengzhou University of Light Industry, Zhengzhou 450002, China

Received Date: 2015-11-19
Available Online: 2016-05-15

Abstract

The length, width and depth of insertion head of micro-channel heat exchanger were selected as investigation factors,then models were set up by using uniform design method, and sensitivity parameters that affected the uniform distribution of the micro-channel heat exchanger fluid flow were analyzed. The results showed that:1) Micro-channel heat exchanger fluid distribution uniformity was not only associated with the state of the fluid flow, but also related to the structure and geometry; so keeping the lower flow rate (0.05~0.10 m/s) of the fluid micro-channel could be better for distribution uniformity. 2) In the case that the inlet flow was constant, fluid flow distribution uniformity was the combined effect of the manifold results of the channel length, width, and the collecting pipe insertion depth. The factors affecting the fluid distribution uniformity in a descending order were the width of the micro-channel, the head insertion depth of micro-channel and the length of the micro-channel.
- microchannel heat extha-nger,
- fluid distribution uniformity,
- uniform design,
- structure paramter,
- sensitivity factor
References
1. [1]
  钟雪雪,刘顺波,舒明均.板翅式换热器的研究进展[J].洁净与空调技术, 2013(4):54.
2. [2]
  刘景成,张树有,周智勇.板翅换热器流道结构改进与流体流动性能分析[J].机械工程学报, 2014(18):167.
3. [3]
  严瑞东,徐博,陈江平,等.微通道换热器两相分配特性对空调系统性能的影响[J].制冷学报,2013(3):20.
4. [4]
  KAILAS L W,HARGUNANI S,ATLURI P, et al.CFD simulation of flow distribution in the header of plate-fin heat exchangers[J].Chemical engineering & technology, 2007, 30(10):1340.
5. [5]
  JUN K L, LEE S Y.Distribution of two-phase annular flow at header-channel junctions[J].Experimental thermal and fluid science, 2004, 28(2/3):217.
6. [6]
  方开泰.均匀设计与均匀设计表[M].北京:科学出版社,1994.
7. [7]
  郭雷,张树生.微细通道流动沸腾换热机理及实验研究[D].济南:山东大学,2011.
Proportional views

Get Citation

PDF

XML

Article Metrics

Article views(955) PDF downloads(62) Cited by()

Ralated

通讯作者: 陈斌, bchen63@163.com

1.
沈阳化工大学材料科学与工程学院沈阳 110142

The sensitivity analysis of fluid distribution uniformity on the structure parameters for micro-channel heat exchanger

Abstract

References

Proportional views

Article Metrics

Ralated

Proportional views

通讯作者: 陈斌, bchen63@163.com