JOURNAL OF LIGHT INDUSTRY

CN 41-1437/TS  ISSN 2096-1553

基于红外热像的气液两相分层流液膜厚度非介入测量

龚金海 ,  梁法春 ,  刘德绪 ,  燕慧

downloadPDF
龚金海, 梁法春, 刘德绪, 等. 基于红外热像的气液两相分层流液膜厚度非介入测量[J]. 轻工学报, 2012, 27(2): 9-12. doi: 10.3969/j.issn.1004-1478.2012.02.003
引用本文: 龚金海, 梁法春, 刘德绪, 等. 基于红外热像的气液两相分层流液膜厚度非介入测量[J]. 轻工学报, 2012, 27(2): 9-12. doi: 10.3969/j.issn.1004-1478.2012.02.003
shu
GONG Jin-hai, LIANG Fa-chun, LIU De-xu and et al. Gas-liquid two phase stratified flow liquid film height non-invasive measurement based on infrared imaging technique[J]. Journal of Light Industry, 2012, 27(2): 9-12. doi: 10.3969/j.issn.1004-1478.2012.02.003
Citation: GONG Jin-hai, LIANG Fa-chun, LIU De-xu and et al. Gas-liquid two phase stratified flow liquid film height non-invasive measurement based on infrared imaging technique[J]. Journal of Light Industry, 2012, 27(2): 9-12. doi: 10.3969/j.issn.1004-1478.2012.02.003
shu

基于红外热像的气液两相分层流液膜厚度非介入测量

  • 中原石油勘探局 勘察设计研究院, 河南 濮阳 457001;

  • 中国石油大学 储运与建筑工程学院, 山东 青岛 266555

  • 基金项目: 国家科技重大专项(2008ZX05017)

  • 中图分类号: O359

Gas-liquid two phase stratified flow liquid film height non-invasive measurement based on infrared imaging technique

  • Survey and Design Inst., Zhongyuan Petroleum Exploration Bureau, Puyang 457001, China;

  • College of Pipeline and Civil Eng., China Univ.of Petroleum, Qingdao 266555, China

  • Received Date: 2011-12-08
    Available Online: 2012-03-15

    CLC number: O359

  • 摘要: 对于输送高压、易燃易爆、强腐蚀性介质的气液两相流管道,电导探针等传统的介入式液膜厚度测量方法不适用.针对这种情况,提出了通过红外热像测量气液两相分层流液膜厚度的新方法:在管道外壁敷设加热带,通过施加恒定热流密度来增加气液相温差,通过采集红外图像识别气液界面获得液膜高度.在建立VOF多相流模型模拟恒定热流密度条件下管截面上温度分布特征基础上,实验在气液两相流环道上进行,采用热像仪采集管壁红外图像,真实液膜厚度由介入式电容探针测量,在试验范围内红外方法液膜厚度测量最大误差8.2%.
    Abstract: Traditional invasive liquid film measurement method such as conductance probe technique is not suitable for the gas-liquid two-phase flow system with high pressure, flammable,combustible and corrosity medium.A novel method was proposed based on infrared imaging for gas-liquid two phase stratified flow liquid film height measurement.In order to improve the measurement accuracy,a heating belt was applied to improve the temperature difference between the gas and liquid,the film height was obtained using infrared imaging to distinguish gas-liquid interface.A VOF multiphase flow model was used to simulate the temperature distribution of the pipe section under constant heat flux,based on this,the experiments were carried out at an air-water two-phase flow loop and the infrared image were obtained using an infrared camera.The gas-liquid interface position was determined according to the temperature gradient characteristics.The measurement results were compared with capacitance probe method.It showed during the experimental range,the maximum measurement error was 8.2%.
    1. [1]

      林宗虎.能源动力中多相流热物理基础理论与技术研究[M].北京:中国电力出版社,2010.

    2. [2]

      Hewitt G F.Measurements of Two Phase Flow Parameters[M].London:Academic Press,1978.

    3. [3]

      Kang H C,Kim M H.The development of a flush wire probes and calibration method for measuring liquid film thickness[J].Int J Multiphase Flow,1992,18(3):423.

    4. [4]

      Salgadoa C M,Pereiraa C M N A,Schirrub R,et al.Flow regime identification and volume fraction prediction in multiphase flows by means of gamma-ray attenuation and artificial neural networks[J].Progress in Nuclear Energy,2010:52(6):555.

    5. [5]

      梁法春,陈婧,曹学文.基于图像处理的分层流持液率测量[J].石油天然气学报,2008,30(4):161.

    6. [6]

      李立超,杨录,张艳花.利用红外图像处理方法检测材料缺陷[J].红外与激光工程,2010,39(2):372.

    1. [1]

      张建栋 , 杨忠泮 , 吴恋恋 , 徐大勇 , 朱萍 , 张雯晶 , 堵劲松 . 基于高光谱成像及机器学习的烟叶糖料液施加量判别模型. 轻工学报, 2024, 39(5): 86-94. doi: 10.12187/2024.05.010

    2. [2]

      贾尚羲 , 张怡雪 , 石盼盼 , 王昱 , 李可 . 不同时长超声波处理对鹰嘴豆分离蛋白乳化液稳定性的影响. 轻工学报, 2024, 39(5): 40-49. doi: 10.12187/2024.05.005

    3. [3]

      李敏 , 贺姗姗 , 杨钰雯 . 改良QuEChERS方法结合超高效液相色谱测定火腿肠中杂环胺类化合物. 轻工学报, 2024, 39(5): 60-70. doi: 10.12187/2024.05.007

    4. [4]

      章存勇 , 庄海锋 , 时雅琪 , 邹鹏 , 丁乃红 , 纵坤 , 贾良元 , 郭东锋 . 国内外雪茄烟叶热解产物差异性研究. 轻工学报, 2024, 0(0): -.

    5. [5]

      章存勇 , 庄海锋 , 时雅琪 , 邹鹏 , 丁乃红 , 纵坤 , 贾良元 , 郭东锋 . 国内外雪茄烟叶热解产物差异性研究. 轻工学报, 2024, 39(5): 118-126. doi: 10.12187/2024.05.014

  • 加载中
WeChat 点击查看大图
计量
  • PDF下载量:  23
  • 文章访问数:  796
  • 引证文献数: 0
文章相关
  • 收稿日期:  2011-12-08
  • 刊出日期:  2012-03-15
通讯作者: 陈斌, bchen63@163.com
  • 1. 

    沈阳化工大学材料科学与工程学院 沈阳 110142

  1. 本站搜索
  2. 百度学术搜索
  3. 万方数据库搜索
  4. CNKI搜索
龚金海, 梁法春, 刘德绪, 等. 基于红外热像的气液两相分层流液膜厚度非介入测量[J]. 轻工学报, 2012, 27(2): 9-12. doi: 10.3969/j.issn.1004-1478.2012.02.003
引用本文: 龚金海, 梁法春, 刘德绪, 等. 基于红外热像的气液两相分层流液膜厚度非介入测量[J]. 轻工学报, 2012, 27(2): 9-12. doi: 10.3969/j.issn.1004-1478.2012.02.003
shu
GONG Jin-hai, LIANG Fa-chun, LIU De-xu and et al. Gas-liquid two phase stratified flow liquid film height non-invasive measurement based on infrared imaging technique[J]. Journal of Light Industry, 2012, 27(2): 9-12. doi: 10.3969/j.issn.1004-1478.2012.02.003
Citation: GONG Jin-hai, LIANG Fa-chun, LIU De-xu and et al. Gas-liquid two phase stratified flow liquid film height non-invasive measurement based on infrared imaging technique[J]. Journal of Light Industry, 2012, 27(2): 9-12. doi: 10.3969/j.issn.1004-1478.2012.02.003
shu

基于红外热像的气液两相分层流液膜厚度非介入测量

  • 中原石油勘探局 勘察设计研究院, 河南 濮阳 457001;
  • 中国石油大学 储运与建筑工程学院, 山东 青岛 266555
  • 收稿日期: 2011-12-08
  • 网络出版日期: 2012-03-15
基金项目:  国家科技重大专项(2008ZX05017)

摘要: 对于输送高压、易燃易爆、强腐蚀性介质的气液两相流管道,电导探针等传统的介入式液膜厚度测量方法不适用.针对这种情况,提出了通过红外热像测量气液两相分层流液膜厚度的新方法:在管道外壁敷设加热带,通过施加恒定热流密度来增加气液相温差,通过采集红外图像识别气液界面获得液膜高度.在建立VOF多相流模型模拟恒定热流密度条件下管截面上温度分布特征基础上,实验在气液两相流环道上进行,采用热像仪采集管壁红外图像,真实液膜厚度由介入式电容探针测量,在试验范围内红外方法液膜厚度测量最大误差8.2%.

English Abstract

参考文献 (6) 相关文章 (5)

目录

/

返回文章

网站版权 © 轻工学报编辑部

地址：河南省郑州市科学大道136号邮编：450001

本系统由北京仁和汇智信息技术有限公司开发 技术支持： info@rhhz.net