IGBT现场失效短路结温测量方法研究
Research on short-circuit junction temperature measurement method of IGBT field failure
-
摘要: 针对IGBT存在的响应速度慢、异质结构导致的热传导系数不均衡等问题，在对IGBT失效机理和现有结温测量模型研究的基础上，提出一种基于热积累的热电模型，以实时准确地测量IGBT结温.该方法在能量平衡的基础上，将IGBT温度的测量转换为测量IGBT某一点的温度，很好地避开了IGBT异质结构问题.Matlab仿真和实验结果表明，二者温度曲线有较好的拟合度，验证了该方法的可行性.Abstract: To overcome the problems of slow response speed and uneven thermal conductivity caused by the heterogeneity structure which exits in recent junction temperature measurements,a thermoelectric model based on heat accumulation was proposed to accurately measure the IGBT junction temperature in real time,based on the study of IGBT failure mechanism and the existing junction temperature measurement models.The IGBT temperature measurement was converted to measure the temperature of a certain point of the IGBT based on the energy balance to avoid the heterogeneity structure problem of IGBT.Matlab simulation and experimental results showed that the two temperature curves have a good degree of fit, verified the feasibility of the proposed method.
-
-
[1]
YANG S,BRYANT A,MAWBY P,et al.An industry-based survey of reliability in power electronicconverters[J].IEEE Transactions on Industry Applications,2011,47(3): 1441.
-
[2]
SONG Y T,WANG B S.Survey on reliability of power electronic systems[J].IEEE Transactions on Power Electronics,2013,28(1):591.
-
[3]
徐帅,杨欢,王田刚,等.电力电子变换器可靠性研究[J].北京交通大学学报(自然科学版),2015,39(5): 125.
-
[4]
王兆安,刘进军.电力电子技术[M].北京:机械工业出版社,2008.
-
[5]
WU R,BLAABJERG F,WANG H,et al.Catastrophic failure and fault-tolerant design of IGBT power electronic converters—An overview[C]//IECON 2013-39th Annual Conference of the IEEE Industrial Electronics Society.Piscataway:IEEE Conference Publications,2013: 507.
-
[6]
LEFEBVRE S,KHATIR Z,SAINT-EVE F,et al.Experimental behavior of single-chip IGBT and COOLMOS devices under repetitive short-circuit conditions[J].IEEE Transactions on Electron Devices,2005,52(2): 276.
-
[7]
BENMANSOUR A,AZZOPARDI S,MARTIN J C,et al,Failure mechanisms of trench IGBT under various short-circuit conditions[C]//2007 IEEE Power Electronics Specialists Conference.Piscataway:IEEE Conference Publications,2007: 1923.
-
[8]
AMMOUS A,AMMOUS K,MOREL H,et al.Electrothermal modeling of IGBTs: application to short-circuit conditions [J].IEEE Transactions on Power Electronics,2000,15(4): 778.
-
[9]
WANG Z Q,SHI X J,TOLBERT L M,et al.Temperature-dependent short-circuit capability of silicon carbide power MOSFETs[J].IEEE Transactions on Power Electronics,2016,31(2): 1555.
-
[10]
BREGLIO G,IRACE A,NAPOL E,et al.Experimental detection and numerical validation of different failure mechanisms in IGBTs during unclamped inductive switching[J].IEEE Transactions on Electron Devices,2013,60(2): 563.
-
[11]
李森.大功率变流器中快速熔断器的设计分析与选型[D].武汉:华中科技大学,2013.
-
[12]
陈明,胡安,唐勇,等.IGBT结温及温度场分布探测研究[J].电力电子技术,2011(7):130.
-
[13]
TSENG H K,WU M L.Electro-thermal-mechanical modeling of wire bonding failures in IGBT[C]//2013 8th International Microsystems,Packaging,Assembly and Circuits Technology Conference (IMPACT).Piscataway:IEEE Conference Publications,2013: 152.
-
[1]
-
点击查看大图
计量
- PDF下载量: 60
- 文章访问数: 733
- 引证文献数: 0
下载:
