基于关联维数的交流接触器故障噪声起因分析
Cause analysis of AC contactor fault noise based on correlation dimension
-
摘要: 将关联维数法引入交流接触器的故障噪声分析,采用互信息法和Cao方法来确定相空间重构的2个重要参数——延迟时间和嵌入维数,利用G-P算法分别计算短路环断裂、磨损、异物入侵、复位弹簧过硬4种不同原因产生的交流接触器故障噪声的关联维数,并与交流接触器正常运行的关联维数进行比较,判断交流接触器故障噪声的起因.实验结果表明,不同故障造成的交流接触器噪声的关联维数是不同的,交流接触器故障噪声关联维数能作为运行噪声起因的一个判据.Abstract: The correlation dimension method was introduced into the causes of the AC contactor fault noise analysis. The mutual information and Cao method decided two important parameters of the phase space reconstruction-delay time and embedded dimension. G-P algorithm separately calculated AC contactor correlation dimension with short circuit ring fracture, wear,foreign matter invasion, stronger reset spring and compared with under normal operation to judge the causes of different AC contactor fault noise. The experimental results showed that correlation dimensions are different in the different fault state. The correlation dimension of AC contactor fault noise can be used as criterion to analyses the causes of running noise.
-
Key words:
- correlation dimension /
- mutual information method /
- Cao method /
- AC contactor /
- fault noise
-
-
[1]
吴晓梅,张认成,杨建红.交流接触器振动噪声性能的在线检测[J].低压电器,2011(18):21.
-
[2]
薛福连.交流接触器运行噪声的消除方法[J].大众用电,2005(8):34.
-
[3]
Peter Grassberger, Itamar Procaccia.Characterization of strange attract ors[J].Phy Rev Lett,1983,50:346.
-
[4]
Kantz H,Schrieber T.Nonlinear Time Series Analysis[M].Cambridge:Cambridge University Press,1999.
-
[5]
党建武,黄建国.基于G.P算法的关联维计算中参数取值的研究[J].计算机应用研究,2004(1):48.
-
[6]
张淑清,贾健,高敏,等.混沌时间序列重构相空间参数选取研究[J].物理学报,2010,59(3):1576.
-
[7]
高宇,黄宜坚.采用关联维的溢流阀故障诊断[J].华侨大学学报:自然科学版,2012,33(3):241.
-
[8]
王旭平,王汉功,陈小虎.关联维数在齿轮泵故障诊断中的应用[J].机床与液压,2009,37(7):252.
-
[9]
孟祥海,王金全,刘渊,等.基于关联维数的柴油机声音信号特征分析[J].内燃机,2011(1):56.
-
[1]
计量
- PDF下载量: 20
- 文章访问数: 910
- 引证文献数: 0